The Mactech Pipe End Measurement System (PEMS) measures distortion, wall-thickness variation and other pipe-end geometry on site. It provides an alternative to third-party dimensioning services at approximately 1/10 of their cost, according to Mactech. In-house measurement also reduces dependency on an external service schedule.
The Mactech Pipe End Measurement System (PEMS) measures distortion, wall-thickness variation and other pipe-end geometry on site. It provides an alternative to third-party dimensioning services at approximately 1/10 of their cost, according to Mactech. In-house measurement also reduces dependency on an external service schedule.
PEMS can be configured for a broad range of industrial pipe sizes and types, with custom construction available for nonstandard specifications. After setup, the system captures 1,300 laser-point dimensions in 50 seconds. The resulting data supports tolerance verification and quality control from the mill through field installation.
| Maximum Outside Diameter (OD) | Imperial | Metric |
|---|---|---|
| Maximum Inside Diameter (ID) | 4.2″ | 107 mm |
| Measurements per Pipe | 1,300 | |
| Accuracy | +/- 0.002″ | 50.8 μm |
| Repeatability | +/- 0.001″ | 25.4 μm |
| Laser Resolution | .0001″ | 2.54 μm |
| Time per End Measure | 50 seconds | |
| Power Source | Battery | |
| Weight | 20 lbs. | 9 kg |
| Accessory |
|---|
| Dedicated laptop pre-installed with user-friendly PEMS software |
| Custom sizing and accessory packages built to spec |
The HADI Technologies team will help you select the right configuration, verify application requirements and provide technical information about Mactech Pipe End Measurement System PEMS.
The right solution starts with a clear brief
The HADI product development and engineering team can adapt a tool, product or system to your application.